10kg Soundproofing Mat - Mass Loaded Vinyl
1.2m wide by 2m long by 5mm thin
What Are The Benefits?
Our 10kg Soundproofing Mat is a flexible 5mm thin mineral loaded soundproofing mat which is designed to block and reduce airborne noise through stud walls and timber joisted floors and ceilings. It is equal to Lead of the same mass in effectiveness and acts as a thin de-coupling sound blocker in stud walls and timber floors. The biggest sound insulation can be achieved when one layer of mass loaded vinyl is sandwiched between two sheets of plasterboard on lightweight structures.
One layer of Soundproofing Mat has an insulation value of 29dB. This value is calculated when the soundproofing mat is hung a curtain. The Soundproofing Mat will not offer the same amount of sound isolation when used in a timber wall or timber floor structure but simply proves that these 10kg Soundproofing Mats are a highly effective method of sound insulation of stud walls, timber floors and ceilings.
Normally a 3dB improvement is equal to a 50% loss in the volume of noise, depending on where you are standing.
For Use On Walls.
Soundproofing Mat is not suitable for gluing directly onto masonry or stud walls. To get the best results from this mass loaded vinyl, it should be sandwiched between two layers of high density Acoustic Plasterboard as part of a stud partition soundproofing solution as detailed above and is suitable to help reduce loud noise nuisance when used in this way.
For Use On Floors
First ensure the floorboards are securely screwed to the floor so as not to squeak when walked over, Green Glue Noiseproofing Tape can be used to help further minimise this. Then use our Acoustic Sealant and fill in the joints between the floorboards and around the edge of the room making the floor is as airtight as possible. Then using our Contact Adhesive glue the layers of soundproofing mat to the timber floor. This will dramatically reduce airborne noise penetrating the floor from below or any airborne noise you create being transmitted to below but will not significantly reduce any footfall or impact noise.
We recommend you use our Specially Formulated Contact Adhesive to assist with installing this product. Please bear in mind that this adhesive is a contact adhesive. Once the product is offered up to the surface and stuck it can't be easily repositioned.
Because our Soundproofing Mat is made from recycled manufacturing materials there may be a 'rubbery' smell when the product is first unwrapped. Usually any smell will dissipate within a few days but as a precaution it is possible to apply a thin layer of polythene over the Soundproofing Mat before the final covering is installed to seal in any possible smells.
What Are The Technical Details?
||10kg Soundproofing Mat
||1.2m x 2m (nominal)
|Area Covered Per Roll
||10kg/m2 (24kg per roll)
||76 (Durometer Shore A, 1 sec dwell)
|Elongation At Break
||2% (4hr @ 100oC)
||<80 mm/min (FMVSS 302)
(Airborne Sound Insulation) -
to ISO R140 Free Hanging Curtain
||20 R (dB)